![]() ![]() The best I could do with Intel Burn Test was to pass the standard test, if I tried the next setting up the program would either shut down with a warning message or the computer would freeze up. ![]() I ran Prime95 on Blend and after two runs one of my cores stops working. At first I tried the recommend Vcore of 1.250v (at optimized default in the Bios as a starting point) with XMP disabled (just in case) and all power saving features turned off. I haven't been so luck yet and if I don't figure things out by tomorrow I will not be able to replace either the motherboard or the processor (if the fault lies with either one). ![]() but I though the 6600K was easy to overclock and at relatively low voltages (I often read of people getting to 4.4GHz at a Vcore of 1.250v without difficulty). I know all overclocks are not the same and I understand that results may very depending on differences in hardware/cooling, etc. I've been having a damned difficult time trying to get a stable overclock with this motherboard (MSI Z170A Gaming M5) and the Intel Skylake 6600K. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |